Plastic plating

全部
  • 全部
  • 产品管理
Search
DZ-2801 Plastic electroplating finishing agent

DZ-2801 Plastic electroplating finishing agent

1. does not damage the plastic workpiece surface gloss. 2. Improve the hydrophilicity of the surface of the workpiece. 3. Effectively reduce the defective rate of coarsening and electroless plating process. 4. Easy management, easy operation.

View More +

DZ-2802 Plastic electroplating roughening process

DZ-2802 Plastic electroplating roughening process

1. Make the surface of the workpiece produce a uniform rough surface. 2. Improve the bonding force between the workpiece and the coating. 3. Improve the wettability and foaming of the roughening liquid, inhibit the escape of acid mist, and reduce the loss of roughening liquid.

View More +

DZ-2803 Plastic electroplating reducing agent

DZ-2803 Plastic electroplating reducing agent

1. Thoroughly remove the influence of roughening liquid on the next process. 2. Can reduce the use of palladium water. 3. Improve the adhesion of the coating.

View More +

DZ-2804 Plastic electroplating palladium activation process

DZ-2804 Plastic electroplating palladium activation process

1. Mixed with hydrochloric acid, dedicated to plastic electroplating, the catalysis of the Pd-Sn system before electroless nickel plating can obtain a uniform electroless coating. 2.DZ-2804 activator is stable and has long service life.

View More +

DZ-2805 Plastic electroplating degumming process

DZ-2805 Plastic electroplating degumming process

1. Effectively reduce the rate of defective products at the contact point of the hanging tool. 2. Wide process range and easy operation. 3. A uniform electroless nickel coating can also be obtained by appropriately reducing the concentration of the palladium activator.

View More +

DZ-2806 Chemical nickel additive for plastic electroplating

DZ-2806 Chemical nickel additive for plastic electroplating

1. This process can deposit a layer of smooth, continuous and good adhesion coating on the activated plastic surface, which can resist contact sintering. 2. This process is stable, easy to operate, low working temperature and cost saving.

View More +

< 1 >